Ceiling Mate Polystyrene Mouldings are specifically intended for stucco or texture finish, to compliment texture ceiling appearance.

TIP: Apply only latex base texture paints.

Texture Finish

Fig. 1: Light Texture

Fig. 2: Medium Texture

Fig. 3: Heavy Texture

How to finish:

1. Lightly mask wall at lower edge of molding to protect the wall.

2. Follow texture paint application instructions carefully.

3. Apply textured paint with a nylon paint brush to ensure uniform distribution. Work on no more than 8’ at a time.

4. Roll slowly back and forth with a slightly damp textured roller
to duplicate adjacent textured ceiling consistency or desired effect. Rolling crosswise will improve appearance.

5. Carefully remove masking tape immediately after completion, while texture is still damp to avoid marring wall surfaces. Let dry
48 hours. Finish if necessary with latex base paint.

6. With a light texture finish, joints may be noticeable for 8 to 10 hours until dry. A slightly heavier application of texture at these points may eliminate this problem more quickly. If joints are still noticeable, a second touch up coat may be applied.
Usually this will blend in perfectly.

7. Apply a light texture finish if you want the molding detail to remain prominent. This is especially significant in high ceiling installations.

Email: Sales@CeilingMate.ca

www.CeilingMate.ca
Or
 Contact us at:
905-723-5532
Fax: 905-723-3781

CeilingMate is a Canadian company.